Publication Date
8-2020
Date of Final Oral Examination (Defense)
7-30-2020
Type of Culminating Activity
Dissertation
Degree Title
Doctor of Philosophy in Materials Science and Engineering
Department
Materials Science and Engineering
Supervisory Committee Chair
Peter Müllner, Ph.D.
Supervisory Committee Member
Paul Simmonds, Ph.D.
Supervisory Committee Member
Joseph Guarino, Ph.D.
Supervisory Committee Member
Ladislav Straka, Ph.D.
Abstract
For magnetic shape memory (MSM) alloys, a magnetic field stimulates a shape change. We use the shape change to build devices such as micro-actuators, sensors, and microfluidic pumps. Currently, (as a novel technology,) devices suffer from some material and magnetic driver shortcomings. Here we address the issues related to operating temperature, repeatability, failure, and magnetic driver development. To increase the operating temperature of the MSM material, we alloyed Fe and Cu to Ni-Mn-Ga. We showed that the element-specific contribution to the valence electron density as parameter systematically determines the effect of each element on the variation of the martensite transformation temperature of the 10M phase. To stabilize the material, we developed a micro-shotpeening process that adds stresses to the material surface, thereby inducing a fine twin microstructure. The treatment allowed nearly full magnetic-field-induced strain, and extended fatigue life of the material from only one thousand cycles in the electropolished state to more than one million cycles in the peened state. We measured the effect of the peening process on material actuation when in MSM pump configuration. In the polished state, the deformation was stochastic, with a sharp-featured, faceted shrinkage. In the treated state, the deformation was smooth and repeatably swept along the surface akin to a wave.
To actuate the MSM micropump without electromotor, we developed a linear electromagnetic actuation device and evaluated its effectiveness in the switching mechanism of the material. By compressing the magnetic field between opposing coils, we generated a strong magnetic field, which caused a localized region to switch at selected poles. In the next iteration of the drive, we inserted the MSM sample between two linear pole arrangements of high pitch density to approximate a moving vertical field. The incremental stepping of the vertical field between poles caused translation of the switched region. The results of this dissertation demonstrate the suitability of MSM alloys for high-precision, persistent, and reliable actuators such as micropumps.
DOI
10.18122/td/1739/boisestate
Recommended Citation
Armstrong, Andrew, "Material Design, Processing, and Engineering Requirements for Magnetic Shape Memory Devices" (2020). Boise State University Theses and Dissertations. 1739.
10.18122/td/1739/boisestate